How To Fill Screw Holes In Van Floor. I've been figuring what to use to seal all the holes in the metal floor of my van, and decided. Floor comes up, holes are filled and treated, insulation laid and then floor back down again. I feel like this provides a good seal and closed the hole up just as well as it was before. Cutting out rusted edges of hole. I applied rust treatment ( this one) to convert any remaining rust before putting the fibreglass on. Simple right?this actually took us about. Sand the holes, paint with primer, and fill with body filler. Sealing/waterproofing bolt and screw holes in the floor. You could then fill the hole in with filler, at which point you could then spray paint over it with primer and a top coat. I would investigate though whether or not this hole was. If they are just screw holes, some type of glue would work fine. After removing the loose paint and loose rust, i cut away any week edges of the metal to give the fibreglass a good solid surface to bond to. My first choice was to put pop rivets back into the holes where they had come out of and this is what i did for about 60 holes.
from boatgenesis.com
I feel like this provides a good seal and closed the hole up just as well as it was before. If they are just screw holes, some type of glue would work fine. Simple right?this actually took us about. Sand the holes, paint with primer, and fill with body filler. Floor comes up, holes are filled and treated, insulation laid and then floor back down again. Sealing/waterproofing bolt and screw holes in the floor. You could then fill the hole in with filler, at which point you could then spray paint over it with primer and a top coat. Cutting out rusted edges of hole. I applied rust treatment ( this one) to convert any remaining rust before putting the fibreglass on. After removing the loose paint and loose rust, i cut away any week edges of the metal to give the fibreglass a good solid surface to bond to.
Filling Screw Holes In A Fiberglass Boat Step By Step Boat Genesis
How To Fill Screw Holes In Van Floor You could then fill the hole in with filler, at which point you could then spray paint over it with primer and a top coat. After removing the loose paint and loose rust, i cut away any week edges of the metal to give the fibreglass a good solid surface to bond to. I applied rust treatment ( this one) to convert any remaining rust before putting the fibreglass on. Cutting out rusted edges of hole. Sand the holes, paint with primer, and fill with body filler. If they are just screw holes, some type of glue would work fine. I've been figuring what to use to seal all the holes in the metal floor of my van, and decided. Sealing/waterproofing bolt and screw holes in the floor. I feel like this provides a good seal and closed the hole up just as well as it was before. I would investigate though whether or not this hole was. Floor comes up, holes are filled and treated, insulation laid and then floor back down again. My first choice was to put pop rivets back into the holes where they had come out of and this is what i did for about 60 holes. Simple right?this actually took us about. You could then fill the hole in with filler, at which point you could then spray paint over it with primer and a top coat.
